Emerson MICRO MOTION 2700 Manuel d'installation télécharger pdf (Page 52)

42 Transmitter Configuration and Use: Series 1000 and 2000 Transmitters

Flowmeter Startup continued

5.5.5 Zeroing with the Zero button

See Figure 5-10 for the flowmeter zero procedure.

Note the following:

• You cannot change the zero time with the Zero button. If you need to change

the zero time, you must use the Communicator or ProLink II software.

• The Zero button is located on the front panel of the transmitter. To press it,

use a fine-pointed object such as the end of a paperclip. Hold the button

down until the status LED on the front panel begins to flash yellow.

Figure 5-10 Zero button – Flowmeter zero procedure

• Model 1500 AN

• Model 2500 CIO

Done

Press Zero button

Status LED flashes yellow

Status LED

turns solid red?

Troubleshoot

Status LED

turns solid green or

solid yellow?

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 263 264

Pas de commentaire

Emerson MICRO MOTION 2700 Manuel d'installation Page 52