Emerson Bristol ControlWave LP Guide d'installation télécharger pdf (Page 23)

Setting up the Host to Reference the I/O Rack

In the "Ext Rack Boards" section, is a list of boards which can reside in the I/O Expansion

Rack. The possible choices include:

ER_DI32 32 Digital Inputs (DI)

ER_DO32 32 Digital Outputs (DO)

ER_AI16 16 Analog Inputs (AI)

ER_AO8 8 Analog Outputs (AO)

ER_HSC12 12 High Speed Counter Channels (HSC)

ER_STAT Statistics

Click on the choice which corresponds to the board in the first I/O slot of the I/O rack, then click

on the [Add] button (or just double-click on the choice). In either case the board will be added to

the "Selected Boards List". Repeat for each additional board residing in the I/O rack, in the

order they reside in the rack.

Click on [Next] to configure the board.

Configure Selected I/O Boards:

To configure a board, click on its name in the "Selected Boards List" and complete the

parameters on the right hand side of the page. NOTE: It is possible to have both local I/O boards

in the ControlWave host controller, and remote I/O boards in the I/O Expansion Rack.

The I/O slot (1 to 8)

in the rack.

We recommend you

do NOT leave this at

‘IGNORE TASK’ but

instead reference on

of your cyclic tasks.

This must match

the IP address

defined for the

Ethernet Port of

the I/O Rack

Click here to

define the

I/O pins

This should be

checked only if this

unit is part of a

redundant pair.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Pas de commentaire

Emerson Bristol ControlWave LP Guide d'installation Page 23