Emerson Bristol ControlWave LP Guide d'installation télécharger pdf (Page 20)

Setting Configuration Parameters

Saving Your Configuration Parameter Changes to the I/O Rack

To save your configuration

changes, click on the [Save to

Rtu] button. This button saves

ALL entries in the pages of

the Flash Configuration Utility

to the I/O Rack. NOTE: If you

haven't signed on prior to

clicking on this button, you

will be prompted to do so.

A prompt will now appear

asking if you want to save the

parameter changes to the

NETDEF file. You should

click on [No], since the I/O

Rack is not considered a node

in the NETDEF file.

At this point, you can click on [Close] to exit the Flash Configuration Utility.

You MUST power-off then re-start to activate the newly saved parameters

At this point, you should power off, and then re-start the I/O Rack for the newly saved

parameters to be activated.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 32 33

Pas de commentaire

Emerson Bristol ControlWave LP Guide d'installation Page 20