Emerson Bristol ControlWave LP Guide d'installation télécharger pdf (Page 13)

Setting Configuration Parameters

Turn off auto local address detection

Use "1" as the local address

Choose

'CWave_RIO'

Finall

, click on

[Finish]

4. First, turn off auto local address detection by answering "No" to the question. Then specify

'1' as the local address, and 'CWave_RIO' as the RTU type. Finally, click on [Finish].

5. At this point, LocalView will create a temporary network with a single 'RTU'. Right-click on

the icon, then choose RTUÆ RTU Configuration Parameters from the pop-up menus.

This will call up the Flash Configuration Utility.

Right-click on the ‘CWave_RIO’ ico

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Pas de commentaire

Emerson Bristol ControlWave LP Guide d'installation Page 13