Emerson Bristol ControlWave LP Guide d'installation télécharger pdf (Page 11)

Setting up the Hardware

Eth erne t

Port

6. Install a ground wire between the Chassis Ground Lug and a known good Earth Ground (see

Section 2.3.1.1 of CI-ControlWaveEXP).

7. Install Watchdog /MOSFET Redundancy Switch wiring (see Section 2.3.5.3 of CI-

ControlWaveEXP). (OPTIONAL - perform this step only if you want to use this feature.)

8. Connect Bulk DC Power to the PSSM Module (see Section 2.3.5.1 and Section 2.3.5.2 of CI-

ControlWaveEXP).

9. Install the Bezel so that it covers the PSSM and CPU Modules (see Section 2.3.7 of CI-

ControlWaveEXP).

10. Plug an Ethernet connection from your network into the

Ethernet port of the I/O Rack.

11. Open the Bezel door, and apply power to the I/O Expansion

Rack by setting the Power Switch on the PSSM Module to the

‘1’ position.

12. When the ControlWave I/O Expansion Rack completes its

power-on sequence, the Port 80 display should be blank.

+VIN

+VINF

-VIN

-VINF

CHASSIS

+12Vdc Bulk Supply #1 Pos. Term.

+12Vdc Bulk Supply #1 Neg. Term.

Chassis Ground

Shared +12Vdc Power Suppl

+VIN

+VINF

-VIN

-VINF

CHASSIS

+24Vdc Bulk Supply #1 Pos. Term.

+24Vdc Bulk Supply #1 Neg. Term.

Chassis Ground

Shared +24Vdc Power Suppl

Typical Configurations

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Pas de commentaire

Emerson Bristol ControlWave LP Guide d'installation Page 11