Emerson Micro Motion F-Series Sensor Manuel d'installation télécharger pdf (Page 9)

CAUTION!

Do not lift the sensor by the electronics or purge connections. Lifting the sensor by the

electronics or purge connections can damage the device.

2.2 Attach extended electronics

If you ordered a sensor with extended electronics, you will need to install the extender

onto the sensor case.

Note

Extended core processors are matched at the factory to specific sensors. Keep each core processor

together with the sensor with which it was shipped.

CAUTION!

Keep the extender and feedthrough clean and dry. Moisture or debris in the extender or

feedthrough can damage electronics and result in measurement error or flowmeter failure.

Procedure

1. Remove and recycle the plastic cap from the feedthrough on the sensor. See

Figure 2-2.

Mounting

Installation Manual 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Emerson Micro Motion F-Series Sensor Manuel d'installation Page 9