Emerson Micro Motion F-Series Sensor Manuel d'installation télécharger pdf (Page 10)

Feedthrough and extender componentsFigure 2-2:

A. Transmitter or core processor

B. Extender

C. Plastic plug

D. Plastic cap

E. O-ring

F. Clamping ring

G. Clamping screw

H. Feedthrough

2. Loosen the clamping screw and remove the clamping ring. Leave the O-ring in place

on the feedthrough.

3. Remove and recycle the plastic plug from the extender.

4. Fit the extender onto the feedthrough by carefully aligning the notches on the

bottom of the extender with the notches on the feedthrough.

5. Close the clamping ring and tighten the clamping screw to 13–18 in-lbs.

(1,5–2 N-m).

Mounting

6 Micro Motion F-Series

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Emerson Micro Motion F-Series Sensor Manuel d'installation Page 10