Emerson Micro Motion F-Series Sensor Manuel d'installation télécharger pdf (Page 14)

Step 3: Terminal connections

Connect the wires to the transmitter

terminals

(see the transmitter manual)

Reinstall and tighten the core processor cover

Core processor

type

From Step 1 or 2

Connect the wires to the core processor terminals:

Red wire > Terminal 1 (Power supply +)

Black wire > Terminal 2 (Power supply –)

White wire > Terminal 3 (RS-485/A)

Green wire > Terminal 4 (RS-485/B)

Connect the wires to the core processor terminals:

Red wire > Terminal 1 (Power supply +)

Black wire > Terminal 2 (Power supply –)

White wire > Terminal 3 (RS-485/A)

Green wire > Terminal 4 (RS-485/B)

Enhanced

core processor

Standard

core processor

1. Reinstall the core processor cover.

2. Torque cover screws to:

• 10–13 in-lbs (1,13–1,47 N-m) for aluminum housing

• Minimum 19 in-lbs (2,1 N-m) for stainless steel

housing

3.3 Connect 9-wire cable

1. Prepare and install the cable according to the instructions in the Micro Motion 9-

Wire Flowmeter Cable Preparation and Installation Guide.

2. Insert the stripped ends of the individual wires into the terminal blocks. Ensure that

no bare wires remain exposed.

Wiring

10 Micro Motion F-Series

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Emerson Micro Motion F-Series Sensor Manuel d'installation Page 14