Emerson Network Router Manuel d'utilisateur télécharger pdf (Page 37)

Installation and Use Manual 31

Using ProLink II Software

ProLink II Setup Transmitter StartupUsing ProLink IIBefore You Begin

To enable inventory reset:

1. Choose

View > Preferences.

2. Select

Enable Inventory Totals Reset.

3. Click

Apply (if necessary).

To manage totalizers and inventories:

1. Choose

ProLink > Totalizer Control or ProLink > CM Totalizer Control (if the concentration

measurement application is enabled in the transmitter). See Figure 3-5.

2. Use the buttons in this window to start, stop, or reset the totalizers and/or inventories.

Note: The

Start, Stop, and Reset buttons displayed under All Totals affect the mass totalizer, the

volume totalizer, and all API-related totalizers.

3. The

Reset Inventories button under All Totals is displayed only if this function is enabled

(see above). Use this button to reset all inventories, including API-related inventories.

Note: ProLink II does not support separate resetting of the API volume totalizer and API volume

inventory. To reset these, you must reset all totalizers or all inventories.

Figure 3-5 Totalizer Control window

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 95 96

Pas de commentaire

Emerson Network Router Manuel d'utilisateur Page 37