Emerson MONITORING OpenComms Manuel d'utilisateur télécharger pdf (Page 15)

System Configuration

3.0 SYSTEM CONFIGURATION

3.1 DIP Switch Settings

A four-position DIP switch is provided, but no user configuration via

DIP switches is necessary at this time.

3.2 Service Terminal

Refer to Accessing the Configuration Port on page 7 for explicit

details on accessing the service terminal / configuration port.

By default, the service terminal communication parameters are:

• 9600 bps

•No parity

• 8 data bits

• 1 stop bit

• Flow Control: None

After connecting to the OpenComms NIC card, press the space bar or

<Enter> key to activate the service terminal session. If no response is

apparent and you have verified connectivity, cycle power on the Open-

Comms NIC and the service terminal sessions should appear automat-

ically.

CAUTION

Cycling power on either the 7200 or the HiPulse UPS is not

recommended unless the unit is in bypass mode. Consult the

UPS user manual for further instructions.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

Emerson MONITORING OpenComms Manuel d'utilisateur Page 15