Emerson Site Manager Manuel d'utilisateur télécharger pdf (Page 44)

36 • Site Manager User Manual 026-1012 Rev 3 06-DEC-2011

Application Setpoint Group Example:

When you have chosen the desired application in-

stance from the Select Application window (Figure 3-

53) and clicked the Save button, the Application Set-

point Group screen for that particular application will

open and display the current application information

from the controller. Figure 3-57 shows an example of

an Application Setpoint Group screen of a Standard

Circuit.

The Application Setpoint Group screen has tabs

containing fields (or points) that can be sent during

setpoint broadcast. Click the Dot image next to the

field name to select the point(s) you wish to send dur-

ing broadcast. (Note that when the Dot image is

clicked, it will be replaced with a Lightning Bolt im-

age to indicate that the point or points have been se-

lected.) Switch through tabs to view and select more

points for broadcast. You can also change point val-

ues and configure log and alarms from this screen by

entering your changes in the point value fields.

Click the Save button from this screen to save the

list of points selected for broadcast along with your

changes, or click Cancel to cancel your changes and

navigate away from the screen.

When saved, the new application setpoint group

will add in the list of current application setpoint

groups.

Figure 3-57 - Application Setpoint Group window (Standard

Circuits shown)

NOTE: An Application Setpoint Group can be

used in as many setpoint broadcasts as desired.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 129 130

Pas de commentaire

Emerson Site Manager Manuel d'utilisateur Page 44