Emerson Site Manager Manuel d'utilisateur télécharger pdf (Page 41)

Activities Menu Menus • 33

If either option is selected, the notification can be

configured. Two notification options are available:

• Pop-up: A popup message will open if you are

logged into the system at the time the message is

sent out. The message will include the name of the

schedule, type, user, and status. Click OK to close

the pop-up.

• Email: An email will be sent to the specified users

or e-mail addresses entered.

There are three options for E-mail Format: HT-

ML, Text, or Cell Phone/SMS Optimized.

The email message will include the name of the

schedule, type, user and status.

The SMS message will include the name of the

schedule and status.

A list of all users will be displayed. If an e-mail ad-

dress was added when the user was set up in the sys-

tem, the e-mail address will be presented below the

username. If no email address was entered, NO

EMAIL SETUP will appear in red text.

Users will have two notification options available:

• When Online – A popup message will be presented,

if you are logged into the system at the time the mes-

sage is sent out.

• Via Email – An email will be sent to the specified

users’ email addresses.

The message will include the name of the sched-

ule, type, user and status.

To close the popup, click OK.

Both an email and popup messages can be sent to

users.

Enter additional email addresses and separate

them with commas (if more than one e-mail is en-

tered).

Emails will be validated and the system will

prompt you if the syntax of an email address is not

correct.

Configuration

Test Send checkbox: (When Setpoint Broadcast is

set as the type of Schedule) When this box is checked,

a Test Send will perform all steps of an actual setpoint

broadcast (except it will not actually execute the

send). The message in red (as shown in Figure 3-50)

next to the Test Send checkbox will notify the users

that selecting the checkbox will not actually send the

values.

Test Send, if selected, will connect to the device

and retrieve any information needed and test for valid

points. This test will show up in the Schedule Manag-

er as a setpoint broadcast entry. You do not have to

recreate the schedule, but can edit the schedule and

uncheck the Test Send option (the details of the test

will be available on the activity history page once the

test has completed). You will know that the setpoint

broadcast was only a Test Send because it will be part

of the activity history details message.

Application Setpoint Group and Target

Controller Group screens (When Setpoint

Broadcast is set as the type of Schedule) (E2/

Einstein controllers only):

You can set up a Target Controller Group where

all application data in the Application Setpoint

Groups will be sent. You can also create, edit, and de-

lete these groups.

To create an Application Setpoint Group, click the

Add New button in the Application Setpoint Group

section (Figure 3-51).

Figure 3-50 - Test Send Checkbox

Figure 3-51 - Application Setpoint Group Section

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 129 130

Commentaires sur ces manuels

Pas de commentaire

Emerson Site Manager Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Emerson Site Manager