Emerson Smart Wireless THUM Adapter Manuel d'installation télécharger pdf (Page 40)

Reference Manual

00809-0100-4075, Rev CA

Section 4: Commissioning

March 2014

Commissioning

AMS Wireless Configurator

When the device has joined the network, it will appear in the Wireless Configurator as illustrated

below.

Troubleshooting

If the device is not operating properly, refer to the troubleshooting section of the manual. The

most common cause of incorrect operation is the Network ID and Join Key. The Network ID and

Join Key in the device must match that of the Smart Wireless Gateway.

The Network ID and Join Key may be obtained from the Smart Wireless Gateway on the

Setup>Network>Settings page on the web server. The Network ID and Join Key may be

changed in the wireless device by using the following Fast Key sequence.

Reference information

Note

In order to communicate with a Field Communicator, the wired device must be powered.

Function Key sequence Menu items

Wireless Setup 1, 4 Smart Power, Network ID, Set Join Key, Radio State

Table 4-2. THUM adapter HART fast key sequence

Function Key sequence Menu items

Device Info 2, 2, 4, 3 Manufacturer, Model, Final Assembly Number, Universal,

Field Device, Software, Hardware, Descriptor, Message,

Date, Model Number I, II, III, SI Unit Restriction, Country

Guided Setup 2, 1 Configure, Guided Setup, Join Device to Network, Configure

Update Rate, Zero Trim, Configure Device Display, Configure

Process Alarms

Manual Setup 2, 2 Configure, Manual Setup, Wireless, Pressure, Device

Temperatures, Device Information, Display, Other

Wireless 2, 2, 1 Network ID, Join Device to Network, Configure Update Rate,

Configure Broadcast Power Level, Power Mode, Power

Source

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 61 62

Pas de commentaire

Emerson Smart Wireless THUM Adapter Manuel d'installation Page 40