Emerson Comverge IntelliTEMP 900 Guide de dépannage télécharger pdf (Page 9)

Getting Started • Homeowner Manual

C. Temporary versus Permanent Hold

A temporary hold can be set when operating in any mode except

for OFF. A temporary hold is set by pressing the

on the

thermostat to adjust the desired temperature. The SET AT indication

of the temperature setpoint will change to HOLD AT and a message

will be cycled in the thermostat messaging display area to conﬁrm

that a temporary hold is set. A temporary hold setpoint will then be

maintained until the start of the next programmed time period or the

RUN softkey is pressed.

A permanent hold can be set when operating in any mode except

for OFF. To set a permanent hold, change the temperature just like

setting a temporary hold. When the desired setpoint is entered, the

user will have approximately 4 seconds to press the PERM HOLD

softkey to convert the temporary hold into a permanent hold. The

SET AT by the setpoint will change to HOLD AT and a message will

be cycled in the thermostat messaging display area to conﬁrm that

a permanent hold is set. If the PERM HOLD softkey is not pressed

within 4 seconds, the hold will remain a temporary hold. A permanent

hold setpoint will override the programmed setpoints and time periods.

A hold will end whenever the RUN softkey is pressed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Emerson Comverge IntelliTEMP 900 Guide de dépannage Page 9