Emerson 5-In-One Learning Light-Up Remote Manuel d'utilisateur télécharger pdf (Page 21)

Operation

device, starting with the most popular codes.

Because of the library’s size, this procedure may

take some time. When the red light blinks three

times, the search of every code is complete.

6. Press

once to lock in the code.

Note:

If the device turns off during the search, but does

not operate after you lock in the code, begin the search

again, pausing longer between key presses.

Checking Your Code

If you set up the remote control using the manual code

search procedure, you can use the following instructions

to find out what code is operating your equipment:

1. On the remote control, press the desired device key

once.

2. Hold down

until the red light blinks twice.

3. Press

9 9 0

. The red light blinks twice.

4. To view the code for the first digit, press

. Count the

number of blinks (for example, if there are three

blinks, the first digit is 3) and write down the num-

ber.

Note:

The red light will not blink if the code digit is a

“0”.

5. Repeat Step 4 three more times for each succes-

sive digit by pressing and releasing

, and then

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Pas de commentaire

Emerson 5-In-One Learning Light-Up Remote Manuel d'utilisateur Page 21