15
?DECF4E:@?)966E **
LIQ_MAN_ABR_5081T-HT/Rev. L January 2015
Engineering Specifications
'+!)*(*
1
. On the Remote, press PROG, NEXT, NEXT, ENTER.
2. Use the arrow buttons to select %?5F4
(conductivity), ?% (Sodium Hydroxide 0-15%),
" (Hydrochloric Acid 0-16%), )%" (Sulfuric Acid
0-30%), )% (Sulfuric Acid 95-99.99%), or F)E
(custom curve) mode. Press ENTER. If you chose F)E,
continue with step 3. If you chose %?5F4 or one of
the preprogrammed % concentration modes, skip
step 3 and go to step 4.
3. 7J@FD6=64E65F)*, you will see the Setup Custom
screen. To move to the custom curve configuration
menu, press ENTER. You will automatically return to
this same Setup Custom screen after configuration is
complete. To continue transmitter display
programming, press NEXT in the Setup Custom
screen.
4. Use the arrow keys to toggle temperature units
between Celsius and Farenheit.
5. Press ENTER then RESET.
6. Press PROG, ENTER.
7. Use the arrow buttons to enter the 4 mA value. Press
ENTER.
8. Use the arrow buttons to enter the 20 mA value.
Press ENTER then RESET.
9. Press PROG, NEXT, ENTER.
10. Use the arrow key to toggle EFE% to On or OFF to
select using either the process temperature (EFE% =
On) or a manual temperature (EFE% = OFF). Press
ENTER. If you selected EFE% = OFF, you will be
prompted to enter the manual temperature; use the
arrow keys, then press ENTER.
11. If you selected @?5+ in step 2, you will see a %#&
(
Temperature Compensation type) screen. Use the
arrow keys to select desired temperature
compensation: ":?C (linear) or ?%? (raw or
uncompensated conductivity). Press ENTER. If you are
in ":?( mode, you can now enter a particular
temperature slope (default is 2%/degC), then press
ENTER to apply the slope.
12. Press RESET.
13. Press CAL, NEXT, NEXT, NEXT, ENTER.
14. Use the arrow buttons to enter the cell constant of
the sensor. Press ENTER, then EXIT.
15. To “zero” the sensor in air, press CAL, NEXT, ENTER.
16. Hold the sensor in air to zero. Press ENTER, then EXIT.
17.If you are measuring % concentration (?%"
)%" or )%) or custom curve (F)E), quick
start is complete; proceed to step 20.
18. If you are measuring conductivity (@?5+), then
standardize the sensor by placing the sensor in a
solution of known conductivity value. Press CAL,
ENTER.
19. Use the arrow buttons to enter the current
conductivity value of the solution. Press ENTER.
20. Press RESET.
*%()**($)#*(*%*%(/+"*
)**$)
1. Press PROGRAM, NEXT, NEXT, NEXT, NEXT, NEXT. The
screen should say N5+"EO. Press ENTER.
2. Use the arrow keys to toggle between nO (retain your
configuration and calibration settings) and /)
(restore factory default settings to all variables).
3. Press ENTER, then EXIT.
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels