Emerson Liebert MicroPOD Maintenance Bypass and Output Distribution Accessory Guide de l'utilisateur télécharger pdf (Page 11)

HARDWIRE CONNECTIONS

Electrical Installation Considerations

The front and bottom of the POD provide alternate conduit entry

points for both the UTILITY and LOAD connections.

Figure 5 Conduit entry

CAUTION

This UPS must be installed by competent electrical

personnel and wired in accordance with local/national

electrical codes.

CAUTION

The utility input supply to the POD must be protected by a

branch rated circuit breaker. The UPS output must also be

protected with a circuit breaker connected to the load, rated

to carry the input current, and be capable of breaking the

maximum expected short circuit current of this branch

circuit. The breaker is to be mounted within 6 feet of the

POD and be readily accessible to the operator. Refer to

Table 1 for breaker specification.

CAUTION

Before installing, open all branch circuit power at the

nearest disconnect, turn UPS off, and disconnect all cords to

and from the UPS.

UPS

AVAIL ABLE

UPS

UTILITY

MAINTENANCE BYPASS

AVAIL ABLE

CONNECT UPS

LINE CORD HERE

IF UTILITY LAMP IS ILLUMINATED

MAINTENANCE BYPASS POSITION

MAY BE SELECTED

SWITCH TO UPS POSITION ONLY

WHEN UPS LAMP IS ILLUMINATED

CAUTION

LOAD

UTILITY

FRONT VIEW

BOTTOM VIEW

Conduit Entry Knockouts

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Pas de commentaire

Emerson Liebert MicroPOD Maintenance Bypass and Output Distribution Accessory Guide de l'utilisateur Page 11