Emerson FIELDVUEDVC2000 Manuel d'instructions télécharger pdf (Page 31)

Instruction Manual

D103176X012

Basic Setup and Calibration

April 2014

Figure 3‐6. XMTR Switch

TRANSMITTER SWITCH

FOR FAIL SIGNAL

+ HIGH (SHOWN) OR

- LOW

Switch #1 Trip Point—Defines the threshold for the limit switch wired to terminals +41 and -42 in percent of calibrated

travel.

Switch #1 Closed—Configures the action of the limit switch wired to terminals +41 and -42. Selecting ABOVE configures

the switch to be closed when the travel is above the trip point. Selecting BELOW configures the switch to be closed

when the travel is below the trip point. Selecting DISABLED removes the icons and status from the display.

Switch #2 Trip Point—Defines the threshold for the limit switch wired to terminals +51 and -52 in percent of calibrated

travel.

Switch #2 Closed—Configures the action of the limit switch wired to terminals +51 and -52. Selecting ABOVE configures

the switch to be closed when the travel is above the trip point. Selecting BELOW configures the switch to be closed

when the travel is below the trip point. Selecting DISABLED removes the icons and status from the display.

Note

Switch #2 is only operational if power is applied to switch #1 also. Switch #2 cannot be used alone.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 107 108

Pas de commentaire

Emerson FIELDVUEDVC2000 Manuel d'instructions Page 31