Emerson 72EE) Manuel d'installation télécharger pdf (Page 11)

5140 Quad-Ethernet Module Firmware Upgrade Appendix-1

Firmware Upgrade

The 5140 QEM firmware can be upgraded over the Ethernet. You need a computer connected to the 5140 QEM over

the Ethernet, an ASCO Power Technologies approved .bin file, and the correct password privileges.

Firmware upgrade capability is accessed on the

Configuration → Edit Mode page.

1. To start a firmware upgrade, click the Press to Upgrade Firmware button on the bottom right corner of the

Configuration

→ Edit Mode page.

2. A pop-up window appears. Click the Continue button, then close the pop-up window.

3. Close the browser window. Then open the browser again. Enter the IP address of the 5140 QEM (see page 2-1).

4. Point to and install the .bin file. The install should take less than 10 seconds.

5. After a successful upgrade, a pop-up message FIRMWARE UPGRADE COMPLETED appears. Click the Reset

button.

6. Close, then reopen the browser window again. Enter the IP address of the 5140 QEM (see page 2-1) to view web

pages.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Emerson 72EE) Manuel d'installation Page 11