Emerson 1410 Manuel d'utilisateur télécharger pdf (Page 12)

January 2015

Quick Start Guide

Figure 6. 1410D Housing Diagram

A. DIN Rail clip

B. Power and Reset indicator lights. During normal operation the power indicator will be green.

During a reset the reset light will turn red. The reset switch should not be enabled during normal

operation.

C. Ethernet port 2. Must have this port enabled when ordered to access. The factory IP address is

192.168.2.10. See Table 2 on page 1-8.

D. Ethernet port 1. Use for standard communication to the webserver or other protocols enabled

on the gateway. The factory IP address is 192.168.1.10. See Table 2 on page 1-8.

E. 5-screw analog terminal blocks female for power and field link connection. See below for the

wiring diagram of the included male connectors.

Best practice

Twisted shielded pair cable is generally used to wire the serial connection, and it is

standard practice to ground the shield on the serial host side leaving the shield

floating on the Gateway side. To avoid grounding issues be sure to insulate the

shield.

Power

Wire a 24 VDC (nominal) Class 2 power source, with at least 250 mA of current, to

the power terminals using the Gateway Terminal Block Diagram shown in

Figure 5.

00825-0200-4410_CB.fm Page 12 Monday, January 19, 2015 9:56 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Emerson 1410 Manuel d'utilisateur Page 12